Cherry Heaven TV provides on-line radio and television programmes using the Cherry Heaven Player. To play, pause, or stop the player, or adjust the volume, click the controls or, whilst it's playing, drag the time-line slider to a new position.

The Cherry Heaven Player has already been downloaded and embedded in this page, so it'll work on any computer in any country. Although it adopts the current interactive colour scheme, it's only saved temporarily on your computer. It doesn't install any adware, key loggers, spy software, or viruses, nor does it affect any other programme.

The Cherry Heaven Player uses internet-standard FLV, MP3, and MP4 formats, with parameters set to achieve a practical balance of audio and video quality set against a likely data-streaming rate.

If your internet connection is capricious, the programme might pause then continue if the data stream can't keep up with the demands of the player.

If you're using a notebook computer, the audio quality will probably be poor and not loud enough. To remedy this, you need some external loudspeakers:

The Cherry Heaven USB Stereo Loudspeakers don't need batteries, installing, or setting up: they're powered by the computer's USB socket and driven by the stereo-out socket. To learn more, use the Cherry Heaven link above the menu bar near the top of the page.

External loudspeakers will improve your enjoyment of music cds, mp3 tracks, on-line movies, dvd movies, video camera movies, games, youtube, and net-phone applications.

In the factory, the casing screws are put in with an electric screwdriver. When removing them, use the correct-size screwdriver. As with all screws, the wrong size screwdriver can damage the head, making them difficult to get out.

The muffle has two elements, one on each side. Looking at the back, the power is connected to the bottom-left element tail, passes through the left-hand element and reappears at the top-left element tail. This is connected, by a separate external wire, to the top-right element tail. The power passes through the right-hand element and the power is connected to the bottom-right element tail.

It's very important that the connectors on the element tails are fully tightened, and that any extra tails are snipped off so that they can't touch the metal back of the kiln.